The common types of bending machine are hydraulic bending machine, CNC bending machine and manual bending machine. Bending machine is generally composed of bracket, worktable, splint, base and other parts. When operating the bending machine, there are some precautions. What are the details?

Precautions for safe operation of bending machine are as follows:

(1) Strictly abide by the safety operation rules of machine tool workers and wear labor protection articles as required.

(2) Before starting, carefully check whether the motor, switch, circuit and grounding are normal and firm, and check whether the operating parts and buttons of the equipment are stuck in the correct position.

(3) Check the coincidence and firmness of the upper and lower dies; check whether the positioning devices meet the processing requirements.

(4) When working, one person shall be responsible for the unified command, so that the operator and the material feeding and pressing personnel can cooperate closely, and the bending signal can be sent only after ensuring that the cooperating personnel are in a safe position.

(5) No one is allowed to stand behind the machine when the machine is working.

(6) It is strictly forbidden to press the folded plate on one end.

(7) If the workpiece or die is found to be incorrect during operation, stop the machine for correction. It is strictly forbidden to correct by hand during operation to prevent hand injury.

(8) It is strictly forbidden to fold the ultra thick iron plate or quenched steel plate, alloy steel, square steel and plate exceeding the performance of the bending machine, so as to avoid damaging the machine tool.

(9) Stop the machine immediately, check the cause and eliminate it in time.

(10) Before stopping the machine, put the block on the lower die under the oil cylinders on both sides, and put the upper slide plate on the block.

(11) First exit the control system program, and then cut off the power supply.